UART guide¶
The serial console (UART) is how you reach the bootloader. It is required for the first install from the stock firmware, and it is the universal recovery path as long as the bootloader is intact.
What you need¶
| Item | Notes |
|---|---|
| USB-UART adapter | 3.3 V logic only. A 5 V adapter can damage the board. |
| Three jumper wires | TX, RX and GND. Do not connect the adapter's power pin. |
| Phillips screwdriver | to open the case |
| Terminal program | screen, minicom, PuTTY or similar |
Connection settings¶
| Setting | Value |
|---|---|
| Speed | 115200 baud |
| Data / parity / stop | 8N1 |
| Flow control | none |
Wiring¶
Locate the UART pads on the board. They are marked for TX, RX and GND.
- Router TX to adapter RX
- Router RX to adapter TX
- Router GND to adapter GND
Cross the data lines: transmit goes to receive. If you see nothing, swap TX and RX before you suspect anything else.
Connect¶
# Linux
screen /dev/ttyUSB0 115200
# macOS
screen /dev/tty.usbserial-XXXX 115200
Power the router on. You should see the boot messages. To stop the boot at the bootloader, press a key when the countdown appears. You are now at the U-Boot prompt, and the installation and recovery steps can continue from there.
Tips¶
- Disconnect the adapter's power wire; the router must power itself.
- Keep the serial session open while you flash; it shows exactly what failed if something does.
- Close the terminal when you are done. A stuck terminal on the modem's AT port (not the board UART) is a different matter, see The 5G modem.
Common questions¶
What UART settings does the Arcadyan AW1000 use?
115200 baud, 8N1, no flow control, at 3.3 V logic. Connect router TX to adapter RX, router RX to adapter TX and ground to ground, and leave the adapter's power pin unconnected.
Can I use a 5 V serial adapter on the AW1000?
No. Use 3.3 V logic only. A 5 V adapter can damage the board.
I see nothing on the AW1000 serial console. What should I check?
Swap the TX and RX wires first, since the data lines must cross. Then check that the grounds are joined, that the speed is 115200, and that you open the terminal before you power the router on.
How do I stop U-Boot on the AW1000?
Power the router on with the serial terminal open and press a key when the countdown appears. You are then at the U-Boot prompt, ready for the installation or recovery steps.